2011.01.25: Recorder Settings for Harmonic Investigations
 ABSTRACT: This white paper describes the best power analyzer setup for investigating a harmonics complaint or evaluating utility and customer compliance to IEEE 519 harmonic distortion limits. Determining the objectives for a power quality monitoring session prior to installing a power analyzer can have a direct impact on instrument setup, selection of a recording location, and evaluation of recorded data. This is especially true when evaluating Power Quality issues that require calculations of various power system parameters for comparison to recommended limits in IEEE standards, or evaluation of utility and customer effects on electric system voltage quality. Power analyzer initialization should therefore include settings that are directly applicable to the specific power quality problem being investigated. An effective evaluation of customer harmonic current pollution and its effects on system voltage distortion and equipment operation requires specific data collection during the recording session. This necessitates the selection of appropriate harmonic measurements during power analyzer setup which may not be included in the power quality analyzer’s default settings. Descriptions follow of harmonic related measurements that are selectable during power analyzer initialization. VTHD Interval Graph: Voltage Total Harmonic Distortion: A graph of VTHD (harmonic RMS voltage as a % of fundamental voltage) vs. time/date during the recording session. This can be used for comparison to the IEEE 519 recommended limit of 5% VTHD (≤69kV at PCC), and for correlation with customer load current variations to help identify the source of harmonic voltage distortion. ITHD Interval Graph: Current Total Harmonic Distortion: A graph of ITHD (harmonic RMS current as a % of fundamental current) vs. time/date during the recording session. This measurement indicates the harmonic distortion of the current waveform during the recording session. Note that since this distortion is expressed as a percentage of fundamental current, this measurement can exceed 100% during light loads. Harmonic Interval Graphs: The magnitude and phase of individual voltage and current harmonics can be recorded as time interval graphs. Individual current harmonic magnitudes (amps, not %THD) are required when comparing utility customer harmonic current levels to IEEE 519 limits, which lists allowable harmonic current distortion as a percentage of IL, the average maximum customer demand current. Since IL is a fixed value for an individual customer, harmonic current magnitudes must be measured for computing individual harmonic distortion and total demand distortion (TDD). Waveform Capture Harmonic Distortion: Captured voltage and current waveforms can provide valuable supplemental information for harmonic investigations. The waveshape or signature of captured current waveforms can identify the type of nonlinear loads being measured. VTHD, ITHD, and individual harmonic content of any stored voltage or current waveform can also be evaluated. |
PLEASE NOTE:
Thanks for your interest in this file. For this download, you will need to sign in or register. Once you have signed in or registered, you will be automatically redirected back to this page.